Mental Workbench

Impossible is easy

User Tools

Site Tools

Trace:
projects:emb_linux_starterkit_wifi

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revisionBoth sides next revision
projects:emb_linux_starterkit_wifi [2013/07/28 20:49] – created mkuciaprojects:emb_linux_starterkit_wifi [2013/07/28 21:22] – mkucia
Line 6: Line 6:
 By default device have enabled tty0 console at serial line connected to on-board USB hub. When board is connected to PC it should see new virtual COM port. By default device have enabled tty0 console at serial line connected to on-board USB hub. When board is connected to PC it should see new virtual COM port.
 The only user on the device is root without password. I am using unmodified stock firmware. The only user on the device is root without password. I am using unmodified stock firmware.
 +
 +  - Connect board to PC using USB cable. Power the board.
 +  - Connect to board using PuTTY (Serial 11500) COM port number depends on user system.
 +  - Start re-boot board
 +  - Login as root
 +  - Create psk hex using [[http://linux.die.net/man/8/wpa_passphrase|wpa_passphrase]] and put it in ''/etc/wpasupplicant.conf'' (''<nowiki>wpa_passphrase network_ssid password >> /etc/wpasupplicant.conf</nowiki>''). 
 +  - Edit '' '' TODO
 +  - Reset network interface ''/etc/init.d/networking reset''
 +
projects/emb_linux_starterkit_wifi.txt · Last modified: 2013/07/28 22:50 by mkucia