Differences

This shows you the differences between two versions of the page.

--- projects:xbr [2013/06/16 22:31] – [Description] mkucia
+++ projects:xbr [2013/06/17 23:14] – [Abstract] mkucia
@@ Line 5: / Line 5: @@
 Additional interface is used to initialize module LEDs and start sync process.
 One can create adapter for a fraction of cost using only several elements.
+{{:projects:xbr.jpg |}}
 ===== Description =====
+Required parts:
+  * Xbox360 RF board
+  * USB cable
+  * MCU
+  * LDO (3.3 [V])
+  * Capacitor/resistor for MCU
 Pinout of the RF board from top:
@@ Line 14: / Line 23: @@
 Board must be powered by 3v3 so I decided to use LDO.
-Furthermore to start pairing process specific command must be sent. I have used MSP430G2231 for this task.
+Furthermore to start pairing process specific serial command must be sent. I have used MSP430G2231 for this task.
 MCU need reset pull-up resistor and decoupling capacitor.
 Pins 1 and 8 are connected to RF board.
+Pairing process starts few seconds after device is powered. No external button needed.
 <code=c>
@@ Line 131: / Line 143: @@
 }
 </code>
-===== Example =====
+===== Notes =====
+  * There is no way to detect if controller is connected without snooping USB. Current and serial responses do not change after connection.
+  * RF board should be easy to get as repair shops have huge stock from broken Xboxs