projects:xbr
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
| projects:xbr [2013/06/16 22:34] – [Example] mkucia | projects:xbr [2013/06/16 22:36] – [Description] mkucia | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| One can create adapter for a fraction of cost using only several elements. | One can create adapter for a fraction of cost using only several elements. | ||
| ===== Description ===== | ===== Description ===== | ||
| + | |||
| + | Required parts: | ||
| + | * Xbox360 RF board | ||
| + | * USB cable | ||
| + | * MCU | ||
| + | * LDO (3.3 [V]) | ||
| + | * Capacitor/ | ||
| Pinout of the RF board from top: | Pinout of the RF board from top: | ||
| Line 14: | Line 21: | ||
| Board must be powered by 3v3 so I decided to use LDO. | Board must be powered by 3v3 so I decided to use LDO. | ||
| - | Furthermore to start pairing process specific command must be sent. I have used MSP430G2231 for this task. | + | Furthermore to start pairing process specific |
| MCU need reset pull-up resistor and decoupling capacitor. | MCU need reset pull-up resistor and decoupling capacitor. | ||
| Pins 1 and 8 are connected to RF board. | Pins 1 and 8 are connected to RF board. | ||
| + | |||
| + | Pairing process starts few seconds after device is powered. No external button needed. | ||
| + | |||
| < | < | ||
projects/xbr.txt · Last modified: 2023/05/07 13:32 by mkucia