projects:emb_linux_starterkit_wifi
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
projects:emb_linux_starterkit_wifi [2013/07/28 20:49] – created mkucia | projects:emb_linux_starterkit_wifi [2013/07/28 22:50] (current) – mkucia | ||
---|---|---|---|
Line 6: | Line 6: | ||
By default device have enabled tty0 console at serial line connected to on-board USB hub. When board is connected to PC it should see new virtual COM port. | By default device have enabled tty0 console at serial line connected to on-board USB hub. When board is connected to PC it should see new virtual COM port. | ||
The only user on the device is root without password. I am using unmodified stock firmware. | The only user on the device is root without password. I am using unmodified stock firmware. | ||
+ | |||
+ | - Connect board to PC using USB cable. Power the board. | ||
+ | - Connect to board using PuTTY (Serial 11500) COM port number depends on user system. | ||
+ | - Start or re-boot board | ||
+ | - Login as root | ||
+ | - Create psk hex using [[http:// | ||
+ | - Edit ''/ | ||
+ | - Comment out current '' | ||
+ | - Add new '' | ||
+ | iface wlan0 inet dhcp | ||
+ | wpa-conf / | ||
+ | - Reset network interface ''/ | ||
+ | - Now device should connect to AP. User can reset device to check if connection is acquired on boot. | ||
+ | |||
+ | If the network connection is successful user can telnet or ssh into board. USB connection is no more needed. | ||
+ | |||
+ | ===== Static IP ===== | ||
+ | User might want to set static IP. It is possible to set static IP in AP((Access Point)) DHCP settings. To set static IP in embedded device | ||
+ | use following changes for ''/ | ||
+ | < | ||
+ | iface wlan0 inet static | ||
+ | wpa-conf / | ||
+ | address 192.168.1.10 | ||
+ | netmask 255.255.255.0 | ||
+ | gateway 192.168.1.1</ |
projects/emb_linux_starterkit_wifi.1375037365.txt.gz · Last modified: 2013/07/28 20:49 by mkucia