projects:emb_linux_starterkit_wifi
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:emb_linux_starterkit_wifi [2013/07/28 21:22] – mkucia | projects:emb_linux_starterkit_wifi [2013/07/28 22:50] (current) – mkucia | ||
---|---|---|---|
Line 9: | Line 9: | ||
- Connect board to PC using USB cable. Power the board. | - Connect board to PC using USB cable. Power the board. | ||
- Connect to board using PuTTY (Serial 11500) COM port number depends on user system. | - Connect to board using PuTTY (Serial 11500) COM port number depends on user system. | ||
- | - Start re-boot board | + | - Start or re-boot board |
- Login as root | - Login as root | ||
- Create psk hex using [[http:// | - Create psk hex using [[http:// | ||
- | - Edit '' | + | - Edit '' |
- | - Reset network interface ''/ | + | - Comment out current '' |
+ | - Add new '' | ||
+ | iface wlan0 inet dhcp | ||
+ | wpa-conf / | ||
+ | - Reset network interface ''/ | ||
+ | - Now device should connect to AP. User can reset device to check if connection is acquired on boot. | ||
+ | If the network connection is successful user can telnet or ssh into board. USB connection is no more needed. | ||
+ | |||
+ | ===== Static IP ===== | ||
+ | User might want to set static IP. It is possible to set static IP in AP((Access Point)) DHCP settings. To set static IP in embedded device | ||
+ | use following changes for ''/ | ||
+ | < | ||
+ | iface wlan0 inet static | ||
+ | wpa-conf / | ||
+ | address 192.168.1.10 | ||
+ | netmask 255.255.255.0 | ||
+ | gateway 192.168.1.1</ |
projects/emb_linux_starterkit_wifi.1375039360.txt.gz · Last modified: 2013/07/28 21:22 by mkucia